Description

VOOPOO PnP X Pod Cartridges with Built-In Coil

VOOPOO PnP X pod cartridges are the integrated-coil version of the PnP X pod: the mesh coil is built directly into the pod shell, so when flavour starts to fade you swap the whole pod rather than changing a separate coil. They are sold in packs of two and available in three resistance options covering MTL, RDL and DTL vaping.

Each pod holds 5ml, fills from the side, and features a 360-degree adjustable airflow ring and 4-layer leak-proof construction. These pods are compatible with the VOOPOO Drag S2, Drag X2, Drag S3, Drag X3 and Argus Pro 2.

VOOPOO PnP X Pod Cartridge Key Features

• Pack of 2 pods
• Three variants: 0.3 Ohm DTL, 0.8 Ohm RDL, 1.0 Ohm MTL
• Built-in mesh coil: replace the whole pod when spent
• 5ml capacity
• Side-fill design
• 360-degree adjustable airflow ring
• 4-layer leak-proof construction
• Magnetic connection to device
• Approximately 100ml coil lifespan per pod
• Compatible with VOOPOO Drag S2, X2, S3, X3 and Argus Pro 2

0.3 Ohm DTL Pod

The 0.3 Ohm variant is designed for a direct-to-lung draw and suits vapers using high-VG shortfills or freebase nicotine at up to 10mg. The airflow ring opens wide to allow a full, unrestricted draw with good vapour volume. This pod suits mid to high-powered settings on compatible devices and is the best choice for vapers who prefer a lung inhale over a mouth-to-lung draw.

0.8 Ohm RDL Pod

The 0.8 Ohm variant produces a restricted direct-to-lung draw: more airflow than a traditional MTL pod but less wide open than the 0.3 Ohm DTL option. It works well with 50/50 or 60/40 e-liquids and nicotine salts up to 20mg. This is a good option for vapers who have moved on from a tight MTL draw but are not yet comfortable with a fully open DTL inhale.

1.0 Ohm MTL Pod

The 1.0 Ohm variant produces the tightest, most cigarette-like draw in the range. It pairs well with 50/50 e-liquids and nicotine salts up to 35mg and is the recommended starting point for vapers switching from smoking. The airflow ring can be closed down further to tighten the draw to personal preference.

Built-In Coil: Swap the Whole Pod

Unlike the original PnP X empty pods, which accept a separate replaceable coil, these cartridges have the mesh coil integrated into the pod body. When flavour fades or the coil reaches the end of its life, the entire pod is discarded and replaced. Each pod is rated for approximately 100ml of e-liquid before replacement is needed. There are no separate coils to purchase or install alongside these pods.

5ml Capacity and Side-Fill Design

Each pod holds 5ml of e-liquid and fills via a side port rather than the base. The fill port is accessed without removing the pod from the device, keeping top-ups straightforward. After filling, replace the fill cap and allow five minutes for the wick to saturate before vaping, particularly when using a fresh pod for the first time.

360-Degree Adjustable Airflow

The airflow ring rotates continuously through 360 degrees rather than clicking between fixed positions, allowing precise fine-tuning of draw resistance rather than a fixed choice between two or three settings. Closing the ring tightens the draw; opening it produces a more airy, direct-to-lung inhale. Scale markings on the ring help you reproduce a preferred setting consistently.

Compatible Devices

VOOPOO PnP X pod cartridges are compatible with the following devices:

• VOOPOO Drag S2
• VOOPOO Drag X2
• VOOPOO Drag S3
• VOOPOO Drag X3
• VOOPOO Argus Pro 2

These pods are not compatible with devices on the original PnP platform, such as the Drag S, Drag X or Argus Pro. If you are unsure which platform your device uses, check the user manual or original packaging before ordering.

What’s in the Box

• 2 x VOOPOO PnP X pod cartridges (one resistance per pack)

Select your resistance variant at the top of the page before adding to basket. No separate coils are required or included.